Hello, I'm Danny.Here is the details you requested. This is a tutorial for you to view on how to replace a fuel filter:https://www.julianum.net/articles/how-to-change-a-fuel-filterI've attached photo steps listed below for you on just how to remove and also replace the fuel filter on her vehicle. Hope this helps and also thanks for utilizing julianum.net.


You are watching: 2000 buick lesabre fuel filter location

*

*

*

*

*

ns am trying to replace the fuel filter on my 2001 Buick LeSabre. First, whereby is the exaclty? Secondly, is it crucial to remove any fuses in the fuse box before removing the old fuel filter? I review somewhere that this is really important. Other areas online, however, carry out not even cite this. Thanks for the help.


See more: The Molecule That Brings Amino Acids To The Ribosomes To Be Assembled Into Proteins Is

Fuel filter is ~ above the frame, below vehicle, just forward the the gas tank, an installed in fuel line. Disconnect the negative battery cable (MUCH better than removed fuse) relieve the fuel mechanism pressure. Twisted the rapid connector 1 / 4 turn in each direction come loosen any type of dirt that might have gathered in the connector. Use compressed air to remove any type of dirt in the connector. Squeeze the plastic tabs the the masculine connector and pull apart. Remove threaded link from the filter inlet. Eliminate the filter. Come install: place the fuel filter, making sure it is facing in the ideal direction. Attach the outlet quick affix line come the fuel filter together follows: action 1: Be certain the connector is clean and that a brand-new plastic retainer is offered on the filter. Action 2: apply a couple of fall of engine oil to the male pipe finish of filter. Step 3: push the fuel line onto the fuel filter till the plastic retainer snaps right into place. Step 4: check that the connector is locked right into place by trying to pull the connector indigenous the filter. Download the threaded link to the inlet next of filter and tighten come 22 ft. Lbs. (30 Nm). Connect the negative battery cable. Pressurize the fuel mechanism by turning the ignition move to the ON position for 2 seconds. Turn OFF the ignition switch for 10 seconds. Turn ON the ignition switch. Check for fuel leaks.